TRITON-270 Intel XScale PXA270 CPU module

• World’s First PXA270 System on Module !
• PXA270 520 MHz CPU (312/416 MHz options)
• 64 MB mobile SDRAM (32 MB option)
• 16 MB wireless Flash (8 MB option)
• LCD controller
• PCMCIA / CF / SD/MMC interfaces
• 3 x SSP, 3 x asynch serial
• USB host and client, IrDA, PWM, I2S, AC’97, Bluetooth UART
• Glueless connection to Ethernet controller
• Programmable core voltage
• Single 3,3V power supply
• Connector: DIMM 200 low profile
• Small size: 67.6 x 31 x 4.2 mm


Overview
The TRITON-270 SBC is a DIMM200 format based on the new Intel XScale PXA270 cpu. Smaller than a credit-card, the TRITON-270 has been designed as an embedded CPU module that you can easily integrate into your new product designs. By using the TRITON-270, you benefit from volume prices and reduced design times. Typically the only part needed is a simple 2 or 4-layer PCB carrier board that contains the peripherals required for your product.

The TRITON-270 was the world’s first PXA270 System On Module (SOM) and started shipping the first week of October 2004.
Development Kit
The Triton Development Kit-3 is based on the Triton-270 module and is supplied with Linux or Windows CE 5.0
PXA270
Designed from the ground up for wireless clients and incorporating the latest Intel advances in mobile technology, the Intel PXA270 processors are the first Intel XScale cpu’s to include :
• Intel Wireless MMX technology that enables high-performance multimedia acceleration with an industry proven instruction set. In addition,
• Intel Quick Capture which is a flexible and powerful camera interface for capturing digital images and video.

While performance abounds in the Intel PXA27x processor, power consumption is also a critical component. The new capabilities of Wireless Intel SpeedStep® Technology provide a quantum leap forward in low-power operation. Finally, the Intel PXA27x family stacks Intel StrataFlash® memory and low-power SDRAM with the processor for more functionality in a smaller footprint.
Visit Intel’s PXA270 webpage
Expansion
The TRITON-270 is supplied with a DIMM200 connector to provide the designer with access to the PXA270’s signals for nearly unlimited expansion. See the Specifications below or download the datasheet for full connector pin-outs.
Low Power Consumption
Perfect for wireless and multimedia battery-powered applications, the TRITON-270 is equipped with ultra-low-power components including mobile 1.8V SDRAM’s and 1.8V Flash.
The TRITON-270 also contains the unique programmable core power generator which allows you to vary the CPU voltage from 1.1V to 1.3V to further reduce consumption. This can be further reduced by using a combination of Intel Wireless SpeedStep technology, sleep-mode and clock-rate selection. With these features it is possible to flexibly control the total power-consumption for any application.

- Sleep Mode : figures to be supplied
- Maximum : figures to be supplied
Block Diagram

Specifications:
Processor XScale PXA270 520 MHz standard, 416MHz and 312 MHz options
Firmware RedBoot
Supported OS Linux 2.6.10
Windows CE 5.0
Memory 64 MByte 1.8V mobile SDRAM (32 MB option)
16 MByte 1.8V wireless flash memory (8 MB option)
Interfaces Glueless connection to 10/100 Mbps Ethernet
LCD enhanced controller
PCMCIA / CF drive
MMC/SDCard
Memory Stick
3 synchronous serial interfaces
3 asynchronous serial interfaces
I²S, AC97
I²C
JTAG
Bluetooth UART
IrDA
GPIO
USB 2.0 On the Go
4-bit SD I/O
MMC/SD Card
Memory Stick
USIM card interface
Keypad controller
ICP
Operating Temp. -0 to +70 degC, extended temperature on request

Comparing the PXA270 to the PXA255

Features that do not exist in the PXA255:
- 256kB internal SRAM
- USB 1.1 host controller
- Baseband/Multimedia Interface
- Memory Stick host controller
- Keypad interface
- Universal SIM interface

Main improvements of PXA270 compared to PXA255’s existing features:
- Power management (Wireless SpeedStep)
- Wireless MMX
- More advanced LCD controller
- 3 instead of 1 SSP
- USB 2.0 device controller instead of USB 1.1
- RTC now can be used with a backup battery
- 4 instead of 2 PWM outputs

Prices and Configuration
Please contact us for latest prices. Different configurations are possible for volume orders - see datasheet.