NXP LPC2468 USB接口解方案
10-bit ADC with input multiplexing among 8 pins.
10-bit DAC.
Four general purpose timers/counters with 8 capture inputs and 10 compare
outputs. Each timer block has an external count input.
Two PWM/timer blocks with support for three-phase motor control. Each PWM has
an external count inputs.
RTC with separate power domain, clock source can be the RTC oscillator or the
APB clock.
2 kB SRAM powered from the RTC power pin, allowing data to be stored when the
rest of the chip is powered off.
WatchDog Timer (WDT). The WDT can be clocked from the internal RC oscillator,
the RTC oscillator, or the APB clock.
Standard ARM test/debug interface for compatibility with existing tools.
Emulation trace module supports real-time trace.
Single 3.3 V power supply (3.0 V to 3.6 V).
Three reduced power modes: idle, sleep, and power-down.
Four external interrupt inputs configurable as edge/level sensitive. All pins on port 0
and port 2 can be used as edge sensitive interrupt sources.
图1.LPC2468方框图
建议的USB接口解决方案
图4.LPC2468 USB OTG端口配置方案:USB端口1 OTG双功能器件,USB端口2主器件
图5.LPC2468 USB OTG端口配置:VP_VM模式
图6.LPC2468 USB OTG端口配置:USB端口2从器件,USB端口1主器件
图7.LPC2468 USB OTG端口配置:USB端口1主器件,USB端口2主器件
更多计算机与外设信息请关注:21ic计算机与外设频道
评论