Controlling an SPI device with the Raspberry Pi

The Raspberry Pi has a Broadcom BCM 2835 chip allowing it to interface with SPI devices on its GPIO pins. There are two chip select pins meaning that the Pi can control two devices simultaneously.

Step 1: Enable SPI on the Raspberry Pi

1. In your Pi’s terminal, run

   sudo raspi-config

2. Go to Advanced Options > SPI

3. Choose “Yes” for both questions then select Finish to exit raspi-config

4. Either reboot your Pi or run this command to load the kernel module

   sudo modprobe spi-bcm2708

Step 2: Install spidev

Spidev is a python module that allows us to interface with the Pi’s SPI bus.Watch movie online The Transporter Refueled (2015)

sudo apt-get update sudo apt-get upgrade sudo apt-get install python-dev python3-dev cd ~git clone https://github.com/doceme/py-spidev.gitcd py-spidev make sudo make install

Step 3: Python script

Finally, we can write and run a python script to control the SPI device.

1. Create a file called spi-test.py in your favorite editor

   #!/usr/bin/pythonimport spidevimport time spi = spidev.SpiDev()spi.open(0, 0)spi.max_speed_hz = 7629# Split an integer input into a two byte array to send via SPIdef write_pot(input): msb = input >> 8 lsb = input & 0xFF spi.xfer([msb, lsb])# Repeatedly switch a MCP4151 digital pot off then onwhile True: write_pot(0x1FF) time.sleep(0.5) write_pot(0x00) time.sleep(0.5)

2. Make the file executable and run it

   chmod +x spi-test.py sudo ./spi-test.py

Notes on spidev

Unless the spi.max_speed_hz field is a value accepted by the driver, the script will fail when you run it. The field can be set to these values on the raspberry pi:

Two SPI devices can be controlled in python by creating two SpiDev objects, one for each device.

spi = spidev.SpiDev() spi.open(0, 0) spi.max_speed_hz = 976000 spi2 = spidev.SpiDev() spi2.open(0, 1) spi2.max_speed_hz = 976000

https://www.takaitra.com/spi-device-raspberry-pi/